Lift components
Artemislift Poland Sp. z o.o. sales all lift components of main global Partners and manufactures own components.
Optical curtains
WECOMXB-Q5 optical curtains have been designed for elevator applications. The unique optical filter technology ensures high immunity of the system to disturbances from sunlight. The controller software detects idle states (the transmitter switches to a partially asleep state, thereby extending the working time of the photo elements) and damage to optoelectronic components. The curtain is equipped with a buzzer that activates 10 seconds after detecting a permanent obstacle. The optical barriers are equipped with a diagnostic system. Using LED diodes, the controller signals the operating status or faults of the system components. The special profile shape allows for installation of barriers in any operating conditions, both in static and dynamic versions. The curtain controller has an output indicating the curtain status (working/fault). This feature ensures compliance with the EN81-20 standard. The curtain responds to the appearance of an object with a size of 5cm in less than 65 milliseconds.

OLS electronic cabin overload measurement system by ASLINE is based on tensometric sensors.
Depending on the version, these sensors can be installed under the cabin floor, on the ropes, or on the cabin frame. All sensors are connected to a central unit. To facilitate connection, the cable leading to the central unit is equipped with a USB connector, which helps avoid mistakes during installation. The central unit is powered by 230VAC and can be programmed with three activation thresholds (minimum, full, and maximum cabin load). Once properly configured, the actual weight inside the cabin is displayed on the screen. An important feature of the central unit is its analog output (standard 0-10V), which can be very helpful in improving the operation of the hoist drive inverter (eliminating the so-called roll-back effect).



Overspeed governous
CAN-LIFT overspeed governous, type CL08, are modern components designed for both new lifts and comprehensive modernizations. Thanks to their compact design and the spring tensioning system for the rope, they can be an ideal solution wherever there is limited space for this element due to the dimensions of the shaft. They are produced in versions with remote triggering (CL08-UZ) and with locking of the governor by a pin/lock for UCM application (CL08-A3 UCM). All models are produced in a bidirectional version. The triggering speed range corresponds to the majority of applications in the market. The overspeed governous have been tested and approved by LIFTINSTITUUT from the Netherlands.




Overspeed governous ASPAR
OSG M and OSG C series overspeed governors are characterized by compact dimensions. Thanks to the use of a sheave with a diameter of 120mm/200mm, they are an ideal solution for use in shafts with reduced dimensions, as well as in headromm and pit. They are also available in versions with an A3 coil (UCM). The spring tension used allows for further reduction of the space occupied by the device.


Rope attachements

Energy accumulating buffers (elastomer)
